Home

Find My Label

BIS Labels buying guide

Find the
right label.

Choose a material, measure your roll, and get the details ready for your next label order.

Illustration of a barcode label feeding off a roll LABEL ROLL / FIG. 01 COREFEED ↓

01 / Material finder

What does your label need to do?

Tell us how you print, what you label, and where it needs to hold up.

Your starting point

Find a label that fits the job.

Answer three questions for a material and adhesive suggestion. Before ordering, confirm it with your printer specifications and test it on the actual surface.

No ribbon

Direct thermal

Prints on heat-sensitive stock. Often a good fit for short-lived shipping and indoor labels.

Uses a ribbon

Thermal transfer

Pairs a compatible ribbon with paper or film. Consider it for labels that need to stay readable longer.

Match the surface

Paper or synthetic?

Start with paper for dry indoor use. Consider a suitable film for moisture, abrasion, or chemical exposure.

02 / Measure your roll

Get the dimensions right.

Measure a label and its liner separately. Then check the core and full-roll size against your printer or applicator.

Label roll diagram marking label width, length, gap, finished web width, corner radius, core inner diameter, and maximum outside diameter.
Label widthAcross the label, side to side.
Label lengthAlong the direction the label feeds.
Finished web widthThe full liner width, including side margins.
GapThe space between consecutive labels on the liner.
Core sizeThe inside diameter of the roll’s center tube.
Max. roll diameterThe largest outside diameter your equipment can accept.
Corner radiusHow rounded the corners are. The example shows ⅛″; confirm your required radius.

Ordering tip: Write the size as width × length in the feed direction. If you’re replacing a roll, keep a sample or a photo of how it loads.

03 / Match unwind direction

Which edge feeds first?

Choose whether the label face is on the outside or inside of the roll. Then match the first edge off the roll to the artwork as it reads upright.

Wound out: #1 top edge first, #2 bottom edge first, #3 right edge first, #4 left edge first.
Wound out: label face is on the outside of the roll.

Select a position to add it to your quote checklist.

04 / Quote checklist

Put your specs in one place.

Add what you know. Copy the checklist to use when you request a quote or talk with a label specialist.

Request a quote ↗

Label diagram